Problem Possible cause Possible solutionThe salt indicator con-tinues to stay on afterthe replenishment ofthe salt container.This can occur when you areusing salt that needs more timeto dissolve.There is no unwanted effect onthe performance of the appli-ance.If after 3 or 4 programmes, thesalt indicator continues to stayon, contact the service.After the checks are completed, activate theappliance. The programme continues fromthe point of interruption.If the problem occurs again, contact theservice.If other alarm codes show, contact the serv-ice.If the washing and drying results are notsatisfactoryWhitish streaks or bluish layers on glassesand dishes• The released quantity of rinse aid is toomuch. Adjust the rinse aid selector to alower position.• The quantity of detergent is too much.Stains and dry water drops on glassesand dishes• The released quantity of rinse aid is notsufficient. Adjust the rinse aid selector toa higher position.• The quality of the detergent can be thecause.Dishes are wet• The programme is without a dryingphase or with a low temperature dryingphase.• The rinse aid dispenser is empty.• The quality of the rinse aid can be thecause.Refer to ‘HINTS AND TIPS’ for otherpossible causes.Technical informationDimensions Width / Height / Depth (mm) 596 / 818 - 898 / 555Electrical connection Refer to the rating plate.Voltage 220-240 VFrequency 50 HzWater supply pressure Min. / max. (bar / MPa) (0.5 / 0.05 ) / (8 / 0.8 )Water supply 1) Cold water or hot water2) max. 60 °CCapacity Place settings 12Power consumption Left-on mode 0.50 WOff-mode 0.50 W1) Connect the water inlet hose to a water tap with a 3/4'' thread.2) If the hot water comes from alternative sources of energy, (e.g. solar panels, aeolian energy), use the hot watersupply to decrease energy consumption.ENGLISH 15