ENGLISH 11Technical dataDimensionsWidth (mm) 590Height (mm) 44Length (mm) 510Voltage (V) 220-240 V ~The technical information are situated in therating plate on the bottom side of the appliance.InstallationUse protective gloves for handling,preparing and installing the product.After unpacking the hob, make sure that ithas not been damaged during transport. Inthe event of problems, contact the dealer oryour nearest After-sales Service.Technical information for the installer- This product can be embedded in aworktop 20 to 60 mm thick.- If there is no oven beneath the hob,insert a separator panel that has asurface at least equal to the openingin the work surface. This panel must bepositioned at a maximum distance of150 mm below the upper surface of thework surface but, in no case less than 20mm from the bottom of the hob.- Before installation, make sure that:- the local gas delivery conditions (natureand pressure) are compatible with thesettings of the hob (see the rating plateand injector table);- the outer surfaces of the furniture orappliances adjacent to the hob are heatresistant according to local regulations;- This appliance is not connected to afume exhaust device. It shall be installedin accordance with current installationregulations. Particular attention shallbe given to the relevant requirementregarding ventilation.- Combustion products are dischargedoutdoors through specific hoods or walland/or window mounted electrical fans.Gas connectionThis operation must be performed by aqualified technician.The gas supply system must comply withlocal regulations to the relavant gasstandard.- You can find specific local regulations forsome countries in the paragraph- “Reference to Local Regulations”. If noinformation concerning your Country is