Daily useWarning! Refer to Safetychapters.Burner overview123451 Burner cap2 Burner crown3 Ignition candle4 Injector5 ThermocoupleIgnition of the burnerAlways ignite the burner beforepositioning pots or pansTo ignite the burner:1. Push the electric ignition button witch ismarked by a little spark , at the sametime turn the relevant control knobanticlockwise to maximum position .2. Keep the knob pushed for about 5 sec;this will allow thermocouple to heat up,and the safety device to switch off,otherwise the gas supply would beinterrupted.3. After the flame is regular, adjust it aspreferred.If after a few attempts the burnerdoes not ignite, check that thecrown and its cap are in correctpositions.Warning! Do not keep controlknob pressed for more than 15seconds. If the burner does notlight after 15 seconds, releasethe control knob, turn it into offposition and wait for at least 1minute before trying to light theburner again.In the absence of electricity youcan ignite the burner withoutelectrical device; in this caseapproach the burner with aflame, push the relevant knobdown and turn it counter-clockwise to maximum gasrelease position.Warning! Maintain extremecaution while operating withopen fire in kitchen environment.Manufacturer declines anyresponsibility in case of misuse offlame.If the burner accidentally goesout, turn the control knob to theoff position and wait for at least1 minute before trying to light itagain.When switching on the mains,after installation or a power cut,it is quite normal for the sparkgenerator to be activatedautomatically.ENGLISH 9