Alarm code Problem• The indicator of the set programme flash-es continuously.• The end indicator flashes 1 time intermit-tently.The appliance does not fill with water.• The indicator of the set programme flash-es continuously.• The end indicator flashes 2 times intermit-tently.The appliance does not drain the water.• The indicator of the set programme flash-es continuously.• The end indicator flashes 3 times intermit-tently.The anti-flood device is on.Warning! Deactivate the appliancebefore you do the checks.Problem Possible cause Possible solutionThe programme doesnot start.The mains plug is not connec-ted in the mains socket.Connect the mains plug.The appliance door is open. Close the appliance door.The fuse in the fuse box isdamaged.Replace the fuse.The delay start is set. Cancel the delay start or waitfor the end of the countdown.The appliance doesnot fill with water.The water tap is closed. Open the water tap.The water pressure is too low. Contact your local water au-thority.The water tap is clogged orthere is limescale on it.Clean the water tap.The filter in the water inlet hoseis clogged.Clean the filter.The water inlet hose has a kinkor a bend.Make sure that the position ofthe hose is correct.The anti-flood device is on.There are water leakages inthe appliance.Close the water tap and con-tact the service.The appliance doesnot drain the water.The sink spigot is clogged. Clean the sink spigot.The water drain hose has akink or a bend.Make sure that the position ofthe hose is correct.ENGLISH 15