IKEA RENGORA Manual
Also see for RENGORA: Installation instructionsManualManualManualManual
                        | |
Problem and alarm code Possible solutionYou cannot activate the appliance. • Make sure that the mains plug is connected tothe mains socket.• Make sure that there is no damaged fuse inthe fuse box.The programme does not start. • Make sure that the appliance door is closed.• If the delay start is set, cancel the setting orwait for the end of the countdown.The appliance does not fill with water.• The end indicator flashes 1 time in-termittently.• Acoustic signal sounds 1 time inter-mittently.• Make sure that the water tap is open.• Make sure that the pressure of the water sup-ply is not too low. For this information, contactyour local water authority.• Make sure that the water tap is not clogged.• Make sure that the filter in the inlet hose is notclogged. Clean the filter.• Make sure that the inlet hose has no kinks orbends.The appliance does not drain the wa-ter.• The end indicator flashes 2 timesintermittently.• Acoustic signal sounds 2 times in-termittently.• Make sure that the sink spigot is not clogged.• Make sure that the drain hose has no kinks orbends.The anti-flood device is on.• The end indicator flashes 3 timesintermittently.• Acoustic signal sounds 3 times in-termittently.• Drain pump runs continuously.• Close the water tap and contact an AuthorisedService Centre.Door cannot be closed. • Make sure that left and right rail of the upperbasket are positioned at the same height.Once you have checked the appliance,deactivate and activate the appliance. Ifthe problem occurs again, contact anAuthorised Service Centre.For alarm codes not described in the table,contact an Authorised Service Centre.ENGLISH 17 |
Related manuals for IKEA RENGORA
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine