IKOM Construction Machinery Intelligent Asphalt Distributor32VI. Maintenance of equipment1. New vehicle run-in and maintenance① The new car has a run-in period of 2500km and the operating time of 60h.② Within 2500KM traveling mileages of the new truck, you must go to the special repair station of the carchassis to do “maintenance handling”;③ Strict maintenance should be carried out in accordance with the provisions in the Section New VehicleRun-In of "Automotive Operation Manual".④ The spreader should be driven at a low speed during the period of the new car's run-in; the asphalt thankshould be below 60% of the rated load.⑤ Every day, check the tightening of bolts at various locations and check the joints of asphalt, fuel oil,hydraulic oil, heat transfer oil, high-pressure air, and cooling water pipes for leakage and looseness.⑥ Check whether the electrical switches and connectors are loose and working normally daily.2. Technical maintenance and lubricationDuring the operation of sprayer, technical maintenance shall be performed timely to ensurethe normal operation of the machine and extend the service life of the machine.In addition to the chassis part of the sprinkler truck must be strictly according to the"automotive manual" for technical maintenance and lubrication at all levels, but also themaintenance and lubrication of the work system shall be made timely.Powertrain lubrication:For more than 200 hours per working time, grease should be added to the drive shaft and pump drive (GeneralPurpose Lithium Grease for cars GB/T 5671-1995).Generator maintenance and lubrication:① Clean the air filter element for more than 100 hours per working time.② Regularly check the oil level, and immediately add if below the scale line (gasoline oil SAE10W-30)③ Regularly remove dirt and asphalt on the surface.Asphalt pump maintenance and lubrication:① Regularly check the asphalt pump input shaft journal for oil leakage, and screw the compression nut inwardsfor 1~2 turns.② For each working time exceeding 100 hours, add 1 to 2 seal packings. Apply high-temperature grease on theinner surfaces of the journal, the seal packing, and the compression nut during the addition of seal packings.Burning system maintenance:① Remove the carbon deposit from the burner nozzle if the working time exceeds 100h.② Clean the fuel filter if the working time exceeds 300h.Hydraulic system maintenance:① Replace the hydraulic oil (Great Wall 68# anti-wear hydraulic oil) for first working time of more than three