Icar RPC 8LGA User Manual

Also see for RPC 8LGA: Quick guide

Contents

Icar RPC 8LGA User Manual Manual pdf 15 page image

ICAR PQS ALL77 rev2 jan1815 / 28Simply hold the dongle up to the front panel, connecting the plugs to the relevant connectors, and the device will be acknowledgedas shown by the LINK LED on the programming dongle flashing green.USB programming dongle code A25060046580008 WIFI programming dongle code A250600465800099 PARAMETER SETTING VIA PCThe PFC Remote monitoring software can be used to transfer (previously programmed) set-up parameters from the RPC 8LGAregulator to the hard drive of the PC and vice versa. The parameter may be partially transferred from the PC to the RPC 8LGAregulator, transferring only the parameters of the specified menus.10 PARAMETER SETTING (SETUP) VIA THE FRONT PANELTo access the programming menu (setup) :To enter parameter programming the unit must be in TEST mode (first programming)or in MAN modeFrom the normal measurement display, press and hold MODE for 3 seconds to recall the main menu. SET is displayed on the maindisplay.If you have set the password (P.21 = ON) instead of SET the display shows PAS (password entry request). Set the numeric passwordusing ▲ ▼ and then press to move to next digit.If the password is correct the unit will show OK U or OK A depending on the entered password is user or the advanced level. Thepassword can be defined with parameters P.22 and P.23. Factory default is 001 and 002 respectively.If the entered password is wrong the unit will show ERR.After having entered the password, the access is enabled until the unit is re-initialized or for 2 minutes without pressing any key.After having entered the password, repeat the procedure to access the parameter setting.Press ▲▼ to select the desired submenu (BAS ADV  ALA ... ) that is shown on the alphanumeric display.The following table lists the available submenus:COD DESCRIPTIONBAS Access to Base menuADV Accesso to Advanced menuALA Accesso to Alarm menuCMD Access to Command menuCUS Access to Custom menuSAVE Exits saving modifications.EXIT Exits without saving (cancel)Total numberof stepsTEST modeindicationModel variatFirmwarerevisionMAN mode ConnectedstepsManual stepselection enabledTot kvarinserted