Icom F3021 Programming

©2007 Icom America Inc. Page 1Icom America, Inc.2380 116 th Ave NEBellevue, WA 98004425.454.7619Front Panel Programming for the F3021/F4021 RadioWhat You Will Need• OPC-478 Cloning Cable• Cloning Software• Squelch Setting Entered in Cloning Software• Frequencies Entered in Cloning SoftwareEnabling the Radio1. Connect the OPC-478 cloning cable and read the radio.2. In the Cloning software, navigate to Maker reserve -> Set Mode Access. Setto Enable. Once this has been enabled, the field in step 2 (following) willappear in the cloning software.3. Navigate to Common -> Common -> Security -> Set Mode Access. Set toEnable.4. Write to the radio.5. Turn off the radio.Selecting Set Mode and Channel1. Press and hold P0 and # (on the keypad) and turn on the radio. The displayshows DEALER.2. Enter in the Dealer Password (shown in Common -> Common -> Security ->Dealer Passcode). The numbers will not appear on the display. The displayshows SETMODE.3. Press P0. The display shows 1 CH00 1.4. Press P3. This allows you to enable channel change (001 Blinks).5. Press P1 to if you want to change zones (banks).6. Press the Up/Down keys to scroll through the channels and select a channel.(Side buttons below PTT.)7. Press P3 to select the channel you want to edit (Channel stops blinking).8. Press the up/down keys to scroll through the parameters you can change forthat channel:• 9-digit number (with lightning bolt pointing down and to the right, for receivefrequency)• 9-digit number (with lightning bolt pointing up and to the right, for transmitfrequency)• RC 1000 (RX tone)• TC 1000 (TX tone)• Alphanumeric text, if you want to rename the channel (shows blank asdefault).Once you have selected a channel, you can change the functions described in thefollowing paragraphs.

/ 2

Related manuals for Icom F3021