193 BASIC OPERATION Selecting an operating bandThe transceiver has a triple band stacking register.This means that the last 3 operating frequencies andmodes used on a particular band are automaticallymemorized.See the table below for a list of the bands availableand the default settings for each register.D Using the band stacking registersq Push [14 5], then select a frequency and an operat-ing mode.• Frequency and operating mode are memorized in thefirst band stacking register.w Push [14 5] again, then select another frequencyand operating mode.• This frequency and operating mode are memorized inthe second band stacking register.e Push [14 5] again, then select another frequencyand operating mode.• This frequency and operating mode are memorized inthe third band stacking register.• When a fourth frequency and operating mode are se-lected on a band, the first register. set in step q, is over-written.Band keysBAND REGISTER 1 REGISTER 2 REGISTER 31.8 MHz 1.900000 MHz CW 1.910000 MHz CW 1.915000 MHz CW3.5 MHz 3.550000 MHz LSB 3.560000 MHz LSB 3.580000 MHz LSB7 MHz 7.050000 MHz LSB 7.060000 MHz LSB 7.020000 MHz CW10 MHz 10.120000 MHz CW 10.130000 MHz CW 10.140000 MHz CW14 MHz 14.100000 MHz USB 14.200000 MHz USB 14.050000 MHz CW18 MHz 18.100000 MHz USB 18.130000 MHz USB 18.150000 MHz USB21 MHz 21.200000 MHz USB 21.300000 MHz USB 21.050000 MHz CW24 MHz 24.950000 MHz USB 24.980000 MHz USB 24.900000 MHz CW28 MHz 28.500000 MHz USB 29.500000 MHz USB 28.100000 MHz CW50 MHz 50.100000 MHz USB 50.200000 MHz USB 51.000000 MHz FM144 MHz 145.000000 MHz FM 145.100000 MHz FM 145.200000 MHz FMGeneral 15.000000 MHz USB 15.100000 MHz USB 15.200000 MHz USB[Example]: 14 MHz bandGENE 50 021 7 24 8 28 914 510 4 18 63.5 21.8 1 7 3144 ENT