Icom IC-A210 Instruction Manual

Also see for IC-A210: Price list Instruction manual Installation guide Instruction manual Service manual

Icom IC-A210 Instruction Manual Manual pdf 10 page image

62 BASIC OPERATION■ Frequency exchanging(Step 2-2)q After selecting the standby frequency, push [↔] to ex-change it with the active frequency.• Adjust the squelch level in the menu mode, if necessary (p. 23).• Rotate [VOL] to set the volume level, if necessary.• When receiving a signal, “RX” appears and audio is heard fromthe speaker or headset.• Further adjustment of audio level may be necessary at thispoint.w Hold down [PTT] to transmit, then speak into the micro-phone.• Transmit indicator “TX” lights.e Release [PTT] to receive.Frequency exchanging can be also performed remotely fromthe yoke-mounted frequency exchange switch.■ Receivingq Select an operating frequency.• Refer to pages 5, 6 for details.• “RX” appears when receiving a signal or opening squelch.w Push [VOL] to open the squelch manually.• Refer to page 20 “Squelch test function” for details.e Rotate the volume control to adjust the audio level.■ Transmittingq Select the yoke-mounted communication/intercom switchto the “communication” position.w Select an operating frequency.• Refer to pages 5, 6 in details.e Push the PTT switch.• “TX” appears.r Speak into the microphone at your normal voice level.• DO NOT set the microphone too closely to your mouth or speaktoo loudly. This may distort the signal.t Release the PTT switch to receive.NOTE: To prevent interference, listen on the frequencybefore transmitting. If the frequency is busy, wait until thefrequency is clear.NOTE: DO NOT hold down [↔] continuously. Other-wise, the standby frequency disappears. If this happens,again hold down [↔] until the standby frequency reap-pears.