103 MEMORY OPERATIONn Programming a memorychannelTo program the memory channels, follow the steps below.q Rotate [DIAL] and [O-DIAL] to set the desred frequencyfor the standby frequency.w Push [RCL] to enter the memory mode.• The channel number appears.• The memory channel name also appears f t has been entered.e Rotate [O-DIAL] to select the desred memory channeltype.• Select regular channel or group memory channel.r Push [MEM], and then rotate [O-DIAL] to select the “RE-PLACE” menu.• The channel number blnks.t Rotate [DIAL] to select a channel to be programmed.y Push [MEM], to program the frequency nto the channel.• “WRITE COMPLETED” appears on the dsplay when the regu-lar memory channel s programmed.u Push [RCL] to ext the memory mode.n Channel selectionThe transcever has 10 channels n the regular memory and200 channels n the group memory. There are 10 channelsn each of 20 groups (GRP01–GRP20).q Push [RCL] to enter the memory mode.• The channel number appears.• The memory channel name also appears f t has been entered.w Rotate [O-DIAL] to select the memory channel type.• Select from regular memory channel or group memory channel.e Rotate [DIAL] to select the desred memory channelnumber.Transferrng the memory channel to the actve fre-quency s necessary f you want to operate on thememory channel frequency.Refer to “Transferrng memory contents” (p. 12) fordetals.r Push [RCL] to change to standby frequency to the se-lected memory channel frequency and ext the memorymode.CH01127.005122.00RX MEMORYNOTE: Hold down [RCL] for 2 seconds to ext the mem-ory mode wthout changng the prevously set standby fre-quency.