Icom IC-A24 Instruction Manual

Also see for IC-A6: Price list Specification sheet Instruction manual Instruction manual Service manual

Icom IC-A24 Instruction Manual Manual pdf 29 page image

257CLONINGCloning allows you to quickly and easily transfer theprogrammed data from one transceiver to anothertransceiver, or, data from a PC to a transceiver, using theoptional CS-A24 (#02) cloning software.Transceiver to transceiver cloningïq Connect the OPC-474 CLONING CABLE with adapterplugs to the [SP/MIC] jack of the master and sub trans-ceivers.• The master transceiver is used to send data to the sub trans-ceiver.w While holding down [MR•MW], push[PWR] to enter the cloning mode (tooperate the master transceiveronly).• “CLONE” appears and the transceiversenter the clone standby condition.e Push [MR•MW] on the master trans-ceiver.• “CL-OUT” appears in the master trans-ceiver’s display.• “COURSE DEVIATION NEEDLES”shows that cloning is taking place• “CL-IN” appears automatically in thesub transceiver’s display.r When cloning is finished, turn power OFF, then ON againto exit the cloning mode.NOTE: DO NOT transfer the data from a IC-A24 to a IC-A6, when the data contains the NAV band data. In suchcase, a cloning error may occur.Cloning using PCïData can be cloned to and from a PC (Microsoft® Windows®XP) using the optional CS-A24 (#02) cloning software andthe optional OPC-478 (RS-232C type), OPC-478U or OPC-478UC (USB type) cloning cable. Consult the CS-A24(#02) cloning software HELP file for details.Cloning errorïNOTE: DO NOT push [ENT•WX] on the sub transceiverduring cloning. This will cause a cloning error.When the display at right appears, acloning error has occurred.In this case, both transceivers automatically return to theclone standby condition and cloning must be repeated.Microsoft and Windows are registered trademarks of Micro-soft Corporation in the U.S.A. and other countries.“COURSE DEVIATIONNEEDLES” shows thatcloning is taking place.2314567910812131114