Icom IC-F210 Service Manual

Also see for IC-F210: Instruction manual Instruction manual

Contents

Icom IC-F210 Service Manual Manual pdf 16 page image

5 - 55-3 SOFTWARE ADJUSTMENTSelect an operation using [↑] / [↓] keys, then set specified value using [←] / [→] keys on the connected computer keyboard.112312121• Operating freq. : 430.000 MHz A490.000 MHz B• Output power : Low1• Connect the RF power meter or 50 Ωdummy load to the antenna connector.• Transmitting• Operating freq. : 430.000 MHz A490.000 MHz B• Output power : High• Transmitting• Output power : Low2• Transmitting• Output power : Low1• Transmitting• Operating freq. : 415.000 MHz A465.000 MHz B• Output power : Low1• IF bandwidth : Wide• Connect an audio generator to the [MIC]jack through the JIG cable and set as:1.0 kHz/40 mVrms• Set an FM deviation meter as:HPF : OFFLPF : 20 kHzDe-emphasis: OFFDetector : (P–P)/2• Transmitting• IF bandwidth : Narrow• Transmitting• Operating freq. : 415.000 MHz A465.000 MHz B• Set to the DTCS set channel, and push[Connect] on the Adjustment software.• Operating freq. : 155.000 MHz• Output power : Low1• Transmitting• IF bandwidth : Narrow• Transmitting• Operating freq. : 430.000 MHz A490.000 MHz B• Output power : Low1• IF bandwidth : Wide• CTCSS : 67 Hz• DTCS code : 007• Set the FM deviation meter as:HPF : OFFLPF : 20 kHzDe-emphasis: OFFDetector : (P–P)/2• No audio applied to the [MIC] connector.• TransmittingREFERENCEFREQUENCY[TXF]OUTPUTPOWER[Power (Hi)][Power (L2)][Power (L1)]FMDEVIATION[MOD W][MOD Ratio]MODULATIONBALLANCE[BAL W][BAL Ratio]CTCSS/DTCSDEVIATON[CTCS/DTCS]RearpanelRearpanelRearpanelRearpanelRearpanelLoosely couple a frequnecycounter to the antenna connec-tor.Connect an RF power meter tothe antenna connector.Connect an FM deviation meterto the antenna connectorthrough the attenuator.Connect an FM deviation meterwith an oscilloscope to theantenna connector through anattenuator.Connect an FM deviation meterto the antenna connectorthrough the attenuator.430.0000 MHz A490.0000 MHz B25.0 W [25 W]45.0 W [45 W]10.0 W [25 W]25.0 W [45 W]2.5 W [25 W]4.5 W [45 W]±4.1 kHz [N/W]±3.3 kHz [N/M]±2.1 kHz±0.8 kHz [N/W]±0.64 kHz [N/W]ADJUSTMENT ADJUSTMENT CONDITION MEASUREMENT VALUEUNIT LOCATIONSet to square waveformA: 400–430 MHz version for [F210], [F211] B: 440–490 MHz version for [F210], [F211], [F221]