6 - 56-3 TRANSMIT ADJUSTMENTSelect an adjustment item using [↑] / [↓] keys, then set to the specified value using [←] / [→] keys on the connected PC's keyboard.ADJUSTMENT ADJUSTMENT CONDITION MEASUREMENT VALUEUNIT OPERATIONOUTPUTPOWER[Power (Hi)]1 • Channel• Transmitting: CH 3 ToppanelConnect an RF power meter tothe antenna connector.5.0 W[Power (L2)] 2 • Channel• Transmitting: CH 4 2.0 W[Power (L1)] 3 • Channel• Transmitting: CH 5 1.0 WMODULATIONBALANCE[BAL (Narrow)]1 • Channel• Preset [MOD Narrow]: CH 13: 60ToppanelConnect the FM deviation me-ter to the antenna connectorthrough an attenuator.Set to square wave form• No audio applied to the JIG cable.• Set an FM deviation meter same as;HPFLPFDe-emphasisDetector: OFF: 20 kHz: OFF: (P–P)/2• Push [P0] key while transmitting.FMDEVIATION(NARROW)[MOD N C]1 • Channel : CH 13 ToppanelConnect the FM deviation me-ter to the antenna connectorthrough an attenuator.±2.05 to ±2.15 kHz• Connect an audio generator to the JIGcable and set as;Frequency : 1.0 kHzLevel : 150 mV rms• Set the FM deviation meter to same condi-tion as "MODULATION BALANCE."• Transmitting(NARROW)[MOD N L]2 • Channel• Transmitting: CH 8(NARROW)[MOD N H]3 • Channel• Transmitting: CH 1(WIDE)[MOD W C]4 • Channel• Transmitting: CH 5 ±4.05 to ±4.15 kHz(WIDE)[MOD W L]5 • Channel• Transmitting: CH 6(WIDE)[MOD W H]6 • Channel• Transmitting: CH 7(MIDDLE)†[MOD M C]7 • Channel• Transmitting: CH 14 ±3.15 to ±3.25 kHz(MIDDLE)†[MOD M L]8 • Channel• Transmitting: CH 15(MIDDLE)†[MOD M H]9 • Channel• Transmitting: CH 16DIGITALDEVIATION*[MOD D C]1 • Preset [Digital Mode] : 7 ToppanelConnect an FM deviation meter tothe antenna connector throughan attenuator.±1.41 to ±1.45 kHz2 • Channel : CH 9• Set the FM deviation meter to same condi-tion as "MODULATION BALANCE."• Transmitting[MOD D L] 3 • Channel• Transmitting: CH 10[MOD D H] 4 • Channel• Transmitting: CH 11CTCSS/DTCSDEVIATION[CTCSS/DTCS]1 • Channel : CH 12 ToppanelConnect an FM deviation meter tothe antenna connector throughan attenuator.±0.68 to ±0.72 kHz• No audio applied to the JIG cable.• Set the FM deviation meter to same condi-tion as "MODULATION BALANCE."• Transmitting†; [EUR-01] only.*; Necessary only when the optional UT-119 is installed.