D TX code channel selectionIf the transceiver has [TX Code CH Select] assigned to it, theindication can be toggled between the operating channelnumber (or name) and TX code channel number (or name).When the TX code channel number (or name) is displayed,[CH Up] or [CH Down] selects the TX code channel.USING [TX CODE CH SELECT] KEY:q Push [TX Code CH Select]— a TX code channel number(or name) appears.w Push [CH Up] or [CH Down] to select the desired TX codechannel.e Push [Call] (or [PTT] during MSK operation) to transmit theselected TX code.r Push [TX Code CH Select] again to return to the operat-ing channel number indication.USING [TX CODE CH UP]/[TX CODE CH DOWN] KEY:If the transceiver has a [TX Code CH Up] or [TX Code CHDown] key assignment, the programmed TX code channelcan be selected directly when pushed.NOTE for PMR or BIIS PMR operation:• The LCD indication does not change when the operatingchannel number (or name) is displayed. (Depending onthe pre-setting)• To check the selected TX code, push [TX Code CHSelect].D TX code number edit(PMR or BIIS PMR operation only)If the transceiver has [TX Code CH Select] or [TX CodeEnter] assigned to it, TX code contents can be edited withinthe allowable digits.USING [TX CODE CH SELECT] KEY:q Push [TX Code CH Select] to enter the TX code channelselection mode.• Select the desired channel before entering the TX code channelselection mode if necessary.w Push and hold [TX Code CH Select] for 1 sec. to enter theTX code edit mode.e Push [TX Code CH Select] to select the desired digit to beedited.• The digit to be edited blinks.r Push [CH Up], [CH Down] or 10-keypad* to set the desireddigit.t Push [TX Code CH Select] to set the digit. The digit to theright will blink automatically.• When the 10-keypad* is used for setting, the digit to the right willblink automatically without pushing [TX Code CH Select].y Repeat r and t to input all allowable digits.u Push [Call] or [PTT] to transmit the edited TX code.*IC-F3062T/IC-F4062T (10-key type) only143 BASIC OPERATION