MAINTENANCE249CLONING238‘‘ Optional UT-96/ UT-105/ UT-108/ UT-109/UT-110/ UT-111 and UT-113 installationYou can install one of the following optional signaling units in thetransceiver. UT-96 2TONE/5TONE UNIT, UT-105 SmarTrunk(TM) LogicBoard, UT-108 DTMF DECODER UNIT , UT-109/ UT-110 SCRAM-BLER UNIT , UT-111 TRUNKING BOARD or UT-113 MAN DOWNUNIT .q Remove the optional connecter access cover (named 2251 OPTsheet).• Insert a screwdriver into thehollow of the chassis, then liftand take away the cover.(The cover can not be usedagain.)w Attach the desired optional unit. Insert the connector tightly toavoid a bad contact.e Remove the paper backing of 2251 OPT sheet supplied as anaccessory.r Attach the new 2251 OPT sheet to the service window.t Program the necessary infor-mation with the cloning soft-ware before operation.Please ask your dealer orsystem operator for details.werq‘‘ CloningCloning allows you to quickly and easily transfer the programmedcontents from one transceiver to another transceiver; or data fromPC to a transceiver using the optional CS-F3G CLONING SOFTWARE.DD Transceiver-to-transceiver cloningq Connect the optional OPC-474 CLONING CABLE to the [SP] jackof the master and slave transceivers.• The master transceiver is used to send data to the slave trans-ceiver.w While pushing [P0] and [YY], turn the transceiver’s power on toenter cloning mode (For both the master transceiver and slavetransceiver).• “CLONE” appears and the transceiver enters the clone standbycondition.e Push [PTT] on the master transceiver.• “CLOUT” appears in the master transceiver’s display.• “CL IN” appears automatically in the slave transceiver’s display.• When cloning is finished, “CLONE” appears in the master trans-ceiver’s display.NOTE: DO NOT push the [PTT] on the slave transceiver duringcloning. This will cause a cloning error.r When cloning is finished, turn power off, then on again to returnto normal operation.NOTE: Transceiver-to-transceiver cloning can not be donebetween 40CH version and 100CH version, or CPU Rev.1.✻and Rev.2.0.• While pushing [P3] and [YY], turn the transceiver’s power on to enterCPU version check mode. CPU revision is displayed (“100CH” displayfor 100CH version only).