Icom IC-F3GT Instruction Manual

Also see for IC-F4GT: Instruction manual Instruction manual Servise manual User manual Quick start guide

Icom IC-F3GT Instruction Manual Manual pdf 26 page image

■ CloningCloning allows you to quickly and easily transfer the programmedcontents from one transceiver to another transceiver; or data fromPC to a transceiver using the optional CS-F3G cloning software.D Transceiver-to-transceiver cloningq Connect the optional OPC-474 cloning cable to the [SP] jack ofthe master and slave transceivers.• The master transceiver is used to send data to the slave trans-ceiver.w While pushing [P0] and [Y], turn the transceiver’s power on toenter cloning mode (For both the master transceiver and slavetransceiver).• “CLONE” appears and the transceiver enters the clone standbycondition.e Push [PTT] on the master transceiver.• “CLOUT” appears in the master transceiver’s display.• “CL IN” appears automatically in the slave transceiver’s display.• When cloning is finished, “CLONE” appears in the master trans-ceiver’s display.NOTE: DO NOT push the [PTT] on the slave transceiver during clon-ing. This will cause a cloning error.r When cloning is finished, turn power off, then on again to returnto normal operation.NOTE: Transceiver-to-transceiver cloning can not be donebetween 40CH version and 100CH version, or CPU Rev.1.✻and Rev.2.0.• While pushing [P3] and [Y], turn the transceiver’s power on to enterCPU version check mode. CPU revision is displayed (“100CH” displayfor 100CH version only).218 CLONING