Icom IC-F4261DT Service Manual

Contents

Icom IC-F4261DT Service Manual Manual pdf 48 page image

3 - 1SECTION 3. DISASSEMBLY INSTRUCTION1. REMOVING THE FRONT UNIT1) Remove 2 knobs and antenna nut from the frontpanel.2) Remove 2 screws from the chassis.3) Disconnect fl at cables from J704, and then removethe chassis from the front panel.2. REMOVING THE MAIN UNIT1) Remove 7 screws from the MAIN UNIT.2) Disconnect fl at cables from J3 and J4, and then re-move the MAIN UNIT from the chassis.Remove with;“ICOM Driver (K)”(8960000110)Antenna nutKnobKnobJACK UNITJ704VRflat cableRelease the locks Pull straightFLAT CABLEFlat cableFlat cableBE CAREFUL about the locks.ChassisJACK UNITJACK UNITJ704ScrewsVRJ704ChassisFRONT UNITJACK UNITJ704VRScrewsMAIN UNITJ5flat cableRelease the locks Pull straightFLAT CABLEFlat cableFlat cableBE CAREFUL about the locks.ChassisMAIN UNITScrewsJACK UNITJ704VRJ3J4flat cableRelease the locks Pull straightFLAT CABLEFlat cableFlat cableBE CAREFUL about the locks.BE CAREFUL about the flat cable when separating thechassis from the front panel.4) Remove 6 screws from the FRONT UNIT.5) Disconnect the fl at cable from J5, and then removethe FRONT UNIT from the chassis.(Continue on the right column.)