1 - 1SECTION 1 SPECIFICATIONS‘‘ GENERAL• Frequency coverage : 400.000–470.000 MHz [USA], [EUR], [GEN]450.000–512.000 MHz [USA]450.000–520.000 MHz [GEN]• Mode : FM• Type of emission :• Number of conventional channels : 128 ch, 8 banks• Antenna connector : SMA type (50 Ω)• Operating temperature range : –30˚C to +60˚C (–22˚F to +140˚F) [USA], [GEN]–25˚C to +55˚C [EUR]• Power supply requirement : 7.2 V DC nominal (negative ground)• Current drain (at 7.2 V DC) :• Dimensions (projections not included) : 56.0(W)×97.0(H)×36.4(D) mm / 2 7⁄32 (W) ✕ 3 13⁄16 (H) ✕ 17⁄16 (D) in• Weight (Including BP-223) : Approximately 280 g (9.88 oz)‘‘ TRANSMITTER• Output power (at 7.2 V DC) : High: 4 W, Low: 1 W• Modulation : Variable reactance frequency modulation• Maximum permissible deviation : ±5.0 kHz (Wide), ±4.0 kHz (Middle), ±2.5 kHz (Narrow)• Frequency error : ±2.5 ppm• Spurious emissions : 70 dB (typical) [USA], [GEN]0.25 μW (≤ 1 GHz), 1.0 μW (≥ 1 GHz) [EUR]• Adjacent channel power : 70 dB min. (Wide, Middle), 60 dB min. (Narrow)• Audio harmonic distortion : 3 % typical (AF 1kHz, 40 % deviation)• Hum and Noise ([USA], [GEN] only) : 40 dB min (46 dB typical) for Wide(without CCITT filter) 34 dB min (40 dB typical) for Narrow• Residual modulation ([EUR] only) : 45 dB min (55 dB typical) for Wide(with CCITT filter) 43 dB min (53 dB typical) for Middle40 dB min (50 dB typical) for Narrow• Limiting charact of modulator : 60–100 % of maximum deviation• Microphone impedance : 2.2 kΩ‘‘ RECEIVER• Receive system : Double conversion superheterodyne system• Intermediate frequencies : 1st IF: 46.35 MHz, 2nd IF: 450 kHz• Sensitivity : 0.25 μV (–119 dBm) typical at 12 dB SINAD [USA], [GEN]0.63 μV (–111 dBm) emf typical at 20 dB SINAD [EUR]• Adjacent channel selectivity : 70 dB min (75 dB typical) for Wide and Middle60 dB min (65 dB typical) for Narrow• Spurious response : 70 dB• Intermodulation rejection ratio : 70 dB min (74 dB typical) [USA], [GEN]65 dB min (67 dB typical) [EUR]• Hum and Noise ([USA], [GEN] only) : 40 dB min (45 dB typical) for Wide(without CCITT filter) 34 dB min (40 dB typical) for Narrow• Hum and Noise ([EUR] only) : 45 dB min (55 dB typical) for Wide(with CCITT filter) 43 dB min (53 dB typical) for Middle40 dB min (50 dB typical) for Narrow• Audio output power : 0.5 W typical at 5% distortion with an 8 Ω load• Squelch sensitivity (at threshold) : 0.25 μV typical [USA], [GEN]0.63 μV (–111 dBm) emf typical [EUR]• Output impedance (Audio) : 8 ΩSpecifications are measured in accordance with EIA-152-C/204D, TIA-603 or EN 300 086.All stated specifications are subject to change without notice or obligation.VERSION[USA], [GEN][EUR]WIDE16K0F3E (25.0 kHz)MIDDLE14K0F3E (20.0 kHz)NARROW11K0F3E (12.5 kHz)8K0F3E (12.5 kHz)RECEIVING TRANSMITTINGStand-by85 mAMax. audio300 mAHigh (4 W)2.0 ALow (1 W)0.8 A