Icom IC-M200 Instruction Manual

Contents

Icom IC-M200 Instruction Manual Manual pdf 13 page image

1041615141312111098765321SCAN OPERATION 410■ Setting TAG channels ■ Starting a scanFor more efficient scanning, you can set the desiredchannel as a TAG channel or remove it from theTAG channels. Channels that are not tagged willbe skipped during a scan. TAG channels can beindependently assigned to each channel group.1. Push [Ù] and [Ú] on the transceiver at the sametime to select the desired channel group.2. Select the desired channel to be set as a TAGchannel.3. Hold down [SCAN] for 1 second to set thedisplayed channel as a TAG channel.• “ ” is displayed.LTo clear the TAG channel setting, repeat step 3.• “ ” disappears.TIP: Clearing (or setting) all TAG channelsWhile holding down [HI/LO] on the microphone, push[SCAN] for 3 seconds (until a long beep changesto 2 short beeps) to clear all TAG channels in theselected channel group.L Repeat the procedure to set all channels as TAGchannels.NOTE: Select the scan type from "Normal (default)"or "Priority." (p. 13)1. Push [Ù] and [Ú] on the transceiver at the sametime to select the desired channel group.2. Set the TAG channels as described to the left.3. Confirm the squelch is closed to start a scan.4. Push [SCAN] to start a Priority or Normal scan.• “ ” blinks during a Priority scan, “ ” blinksduring a Normal scan.L When a signal is detected, scan pauses until thesignal disappears or resumes after pausing5 seconds, according to the Scan resume timersetting. (p. 13) (Channel 16 is still monitoredduring Priority scan.)L Push [Ù] or [Ú] to check the scanning TAG channels,to change the scanning direction or resume the scanmanually.L A beep sounds and “ ” blinks when a signal isreceived on Channel 16 during Priority scan.5. Push [SCAN] again to stop the scan.