4812 COMMANDMIC II™ HM-157 Setting TAG channelsq While pushing [H/L], push [CH/WX• U/I/C ] severaltimes to select the desired channel group (USA, INT orCAN).w Push [YY] or [ZZ] to select the desired channel to be set asa TAG channel.e Push [SCAN• ] for 1 sec. to set the displayed channelas a TAG channel.• “ ” appears in the display.r To cancel the TAG channel setting, repeat step e.• “ ” disappears.✔ Clearing (or setting) all tagged channelsWhile pushing [H/L], push [SCAN• ] for 3 sec. (until a longbeep changes to 2 short beeps) to clear all TAG channels inthe channel group.• Repeat above procedure to set all TAG channels. Starting a scanSet scan type (Priority or Normal scan) and scan resumetimer in advance, using Set mode. (p. 32)q While pushing [H/L], push [CH/WX• U/I/C ] severaltimes to select the desired channel group (USA, INT orCAN).w Set TAG channels as described at left.e Make sure the squelch is closed to start a scan.r Push [SCAN• ] to startPriority or Normal scan.• “ ”or “ ” appears atthe channel comment indicatorduring Priority or Normal scan,respectively.• When a signal is detected, scanpauses until the signal disap-pears or resumes after pausing5 sec. according to the Set mode setting (Channel 16 is stillmonitored during Priority scan).• Push [YY] or [ZZ] to check the scanning TAG channels, to changethe scanning direction or resume the scan manually.• “ ” blinks at the channel comment indicator and a beep tonesounds when a signal is received on Channel 16 during Priorityscan.t To stop the scan, repeat step r.TAGDWTAGTAGDWDuring normal scan.