Icom IC-M59euro Instruction Manual

Also see for IC-M59euro: Instruction manual

Icom IC-M59euro Instruction Manual Manual pdf 14 page image

D Setting tag channelsYou can specify channels as tag channels for efficient scanning.➥ Select the desired channel, then push and hold[SCAN•TAG] for 1 sec. to toggle the tag setting.✔ Clearing all tag channels:While pushing [HI/LO], push and hold [ SCAN•TAG] for 3 sec.until the long beep becomes 2 short beeps.D Scan operation➀ Be sure the squelch is set to the threshold point.➁ Push [SCAN] to start scanning.• “SCAN” appears and flashes in the function display.• “16” appears during priority scan.➂ To stop the scan, push [SCAN] again.• “SCAN” disappears.3 BASIC OPERATION10 Scan functionThe transceiver has a high speed scan function (8 chan-nels/sec.) for standing by on utility signals.Two scan types are available: priority scan (checks channel16 while scanning all tag channels) and normal scan (scansall tag channels in sequence). These scans can be selectedin set mode (p. 19).✔ Scan resume timer:When a signal is detected, scan pauses until the signal dis-appears or resumes after pausing 5 sec., according to the setmode setting. (p. 19)✔ Confirming tag channels:While operating scan, rotate the channel selector.• Only tag channels are selected.• Stop rotating the channel selector to resume scan.INTTAG Appears when the channel isspecified as a tag channel.NOTE: For U.K. and Italy versions, tag channels can beset separately for each channel group (INT, USA). Selectthe desired group in advance.TAGTAGTAGTAGTAGTAGTAGTAGTAGTAGTAGTAGPriority scan Normal scan