INTRODUCTION DANGERThis service manual describes the latest service informationfor the IC-V8000 VHF FM TRANSCEIVER at the time of pub-lication.ORDERING PARTSBe sure to include the following four points when orderingreplacement parts:1. 10-digit order numbers2. Component part number and name3. Equipment model name and unit name4. Quantity required<SAMPLE ORDER>1110003200 S.IC TA31136FN IC-V8000 MAIN UNIT 5 pieces8810006050 Screw Icom screw E7 IC-V8000 Chassis 10 piecesAddresses are provided on the inside back cover for yourconvenience.NEVER connect the transceiver to an AC outlet or to a DCpower supply that uses more than 16 V. This will ruin thetransceiver.DO NOT expose the transceiver to rain, snow or any liquids.DO NOT reverse the polarities of the power supply whenconnecting the transceiver.DO NOT apply an RF signal of more than 20 dBm (100mW)to the antenna connector. This could damage the trans-ceiver's front end.REPAIR NOTES1. Make sure a problem is internal before disassemblingthe transceiver.2. DO NOT open the transceiver until the transceiver is dis-connected from its power source.3. DO NOT force any of the variable components. Turnthem slowly and smoothly.4. DO NOT short any circuits or electronic parts. An insulat-ed turning tool MUST be used for all adjustments.5. DO NOT keep power ON for a long time when the trans-ceiver is defective.6. DO NOT transmit power into a signal generator or asweep generator.7. ALWAYS connect a 50 dB to 60 dB attenuator betweenthe transceiver and a deviation meter or spectrum ana-lyzer when using such test equipment.8. READ the instructions of test equipment thoroughlybefore connecting equipment to the transceiver.To upgrade quality, any electrical or mechanical parts andinternal circuits are subject to change without notice orobligation.VERSIONAsiaC.S.AmericaU.S.A.SYMBOLSEACSACSA-1USA-2USA-3SUPPLIED MICROPHONEHM-118NHM-118TNHM-133VHM-118TANfineline6