Icom iC-F3062T Instruction Manual

Also see for IC-F3062S: Servise manual Service manual Service manual Service manual Instruction manual

Icom iC-F3062T Instruction Manual Manual pdf 17 page image

133BASIC OPERATION3Receiving and transmitting■NOTE: Transmitting without an antenna may damage thetransceiver. See page 1 for accessory attachments.Receiving:Rotate [VOL] to turn the power ON.qPush [CH Up] or [CH Down], or rotate [ROTARY SELEC-wTOR]* to select the conventional system channel, in se-quence.*Depending on the pre-setting.When receiving a call, adjust the audio output level to aecomfortable listening level.Transmitting:Wait for the channel to become clear to avoid interference.Push [Call] when initiating a call from your side.q• Coded audio may be heard from the transceiver, then “ ” ap-pears.• This operation may not be necessary depending on your signal-ing system. Ask your dealer for details.While pushing and holding [PTT], speak into the micro-wphone at a normal voice level.Release [PTT] to return to receive.eNOTE: To maximize the readability of your signal;1. Pause briefly after pushing [PTT].2. Hold the microphone 5 to 10 cm (2 to 4 inches) fromyour mouth, then speak into the microphone at a normalvoice level.Transmitting notesD• Transmit inhibit functionThe transceiver has several inhibit functions which restricttransmission under the following conditions:- The channel is in mute condition (‘Inaudible’ condition;“ ” does not appear.)- The channel is busy.- Un-matched (or matched) CTCSS is received.(Depending on the pre-setting.)- The selected channel is a ‘receive only’ channel.• Time-out timerAfter continuous transmission for the pre-programmed timeperiod, the time-out timer is activated, causing the transceiverto stop transmitting.• Penalty timerOnce the time-out timer is activated, transmission is furtherinhibited for a period determined by the penalty timer.