62OPERATION Turning power ONq Push [ ] to turn the power ON.w If the transceiver is programmed for a start up passcode,input the digit codes as directed by your Dealer.• The keys in the table below can be used for password input:• The transceiver detects numbers in the same block as identical.Therefore “01234” and “56789” are same.e When all channel indicator LEDs still blink after inputting 4digits, the input code number is incorrect. Turn the poweroff and start over in this case. Channel selectionSeveral types of channel selection are available. The meth-ods may differ according to your system setup.NON-BANK TYPE:Push [CH UP]/[CH DN] to select the desired operating chan-nel, in sequence; or, push one of the [CH 1] to [CH 4] keys toselect a channel directly.BANK-TYPE:Push [BANK] to toggle between bank 1 and 2.AUTOMATIC SCAN TYPE:Channel setting is not necessary for this type. When turningthe power ON, the transceiver automatically starts scanning.Scanning stops when receiving a call or when taking themicrophone off hook.KEYNUMBER 0 1 2 3 45 6 7 8 9

explicit definitions

PANEL DESCRIPTION

i programmable function keys

I Turning power ON

D Transmitting notes

d scrambler function

I Rear panel and connection

i supplied accessories

i mounting the transceiver

I Optional OPC-617 installation

i fuse replacement

Icom iF110S Instruction Manual

receiver circuits

transmitter circuits

pll circuits

power supply circuits

main unit

IC-F110S

I Function LED

I Programmable function keys

OPERATION

I Receiving and transmitting

D Scrambler function

CONNECTION AND MAINTENANCE

I Supplied Accessories

I Mounting the transceiver

I Optional UT-109/UT-110 installation

I Antenna

OPTIONS

IC-F210S

iF110S

iF210S