3 BASIC OPERATIOND TX code number edit (PMR operation only)If the transceiver has [TX Code CH Select] or [TX CodeEnter] assigned to it, TX code contents can be edited withinthe allowable digits.USING [TX CODE CH SELECT] KEY:q Push [TX Code CH Select] to enter the TX code channelselection mode.• Select the desired operating channel before entering the TXcode channel selection mode if necessary.w Push [TX Code CH Select] for 1 sec. to enter the TX codeedit mode.• The digit to be edited blinks.e Push [TX Code CH Select] to select the desired digit to beedited.r Push [CH Up]/[CH Down] to select the desired digit.t Push [TX Code CH Select] to set. The digit to the right willblink automatically.y Repeat r and t to edit all allowable digits.u After editing, push [TX Code CH Select] to set.• Return to the stand-by mode.i Push [Call] to transmit.USING [TX CODE ENTER] KEY:q After pushing [TX Code CH Select], push [CH Up] or [CHDown],or push [TX Code CH Up] or [TX Code CH Down] to selectthe desired TX code channel.w Push [TX Code Enter] to enter the TX code edit mode.• The digit to be edited blinks.e Push [TX Code Enter] to select the desired digit to be ed-ited.r Push [CH Up]/[CH Down] to select the desired digit.t Push [TX Code Enter] to set. The digit to the right will blinkautomatically.y Repeat r and t to edit all allowable digits.u After editing, push [TX Code Enter] to set.• Return to the stand-by mode.i Push [Call] to transmit.D DTMF transmissionIf the transceiver has [DTMF Autodial] assigned to it, theautomatic DTMF transmission function is available. Up to 8DTMF channels are available.q Push [DTMF Autodial]— a DTMF channel appears.w Push [CH Up] or [CH Down] to select the desired DTMFchannel.e Push [DTMF Autodial] to transmit the DTMF code.15