Icom ic-F5122D Instruction Manual

Also see for IC-F5122D: Service manual Instruction manual Operating guide

Contents

Icom ic-F5122D Instruction Manual Manual pdf 15 page image

102BASIC OPERATION12345678910111213141516D Transmitting notes• Transmit inhibit functionThe transceiver has several inhibit functions which restricttransmission under the following conditions:- The channel is in the ‘Inaudible’ (mute) mode; “ ” (Audibleicon) does not appear.- The channel is busy. However, depending on the prepro-grammed settings, you can transmit when the call includesan unmatching (or matching) CTCSS (DTCS), CC, or Indi-vidual or Talkgroup ID.- The selected channel is a ‘receive only’ channel.• Time-out timerIf continuous transmission exceeds the pre-programmedtime-out timer limit, the transmission is cut off.• Penalty timerAfter the transmission is cut off by the time-out timer, trans-mission is further inhibited for the pre-programmed penaltytimer period.• PTTID callThe transceiver automatically sends the 5-tone, DTMF, BIISor digital ANI ID code when [PTT] is pushed (at the begin-ning of the transmission), and/or when it is released (at theend of transmission), depending on the preprogramming.D TX code channel selectionIf the transceiver has a key assigned to [TX Code CH Select],the display can be toggled between the operating channelnumber (or name) and TX code channel number (or name).When the TX code channel number (or name) is displayed,[CH Up] or [CH Down] selects the TX code channel.USING [TX CODE CH SELECT] KEY:q Push [TX Code CH Select]— a TX code channel number(or name) appears.w Push [CH Up] or [CH Down] to select the desired TX codechannel.e After selecting, push [TX Code CH Select] to set.• Return to the stand-by mode.r Push [Call] to transmit the selected TX code.USING [TX CODE CH UP]/[TX CODE CH DOWN] KEY:If the transceiver has a key assigned to [TX Code CH Up] or[TX Code CH Down], the programmed TX code channel canbe directly selected when pushed.