Ideal Boilers Classic FF 340 LF Installation And Servicing Manual

Also see for Classic FF 340 LF: User guide

Classic FF 340 - 360 LF - Installation & Servicing 17INSTALLATIONREAR FLUE OUTLET1. Pull the flue through the wall mounting plate andlocate the 3 studs in the holes in the back panel.2. Secure the flue to the boiler using the three M5wing nuts provided.3. Pull the flue extension tube and engage onto thefan. Locate and secure with the M4 screwattached to the fan.Note.The sealing ring studs will locate in the back panelone way only. This will ensure that the terminal grilleis correctly aligned.19 MOUNTING THE BOILERNote.Have ready to hand the M8 screw,washer and rectangular plate supplied in thehardware pack. For downward routing ofpipes the M5 spacer (supplied in theDownward Piping Kit) should now be fitted tothe back of the boiler.1. Lift the boiler onto the wall mounting platehooks as shown.Do not use the burner / controls forlifting2. Fit the M8 screw, washer and rectangularplate to retain the boiler.Note.Before fully tightening the M8 screw, checkthe boiler alignment, using a spirit level, andadjust as necessary with the jacking screw.20 CONNECTING THE FLUE TO THE BOILERThis plate allows neat concealment and full compression of therubber seal. Its use is not essential if the flue hole and flue ductshave been accurately cut and the outside wall face is flat.1. Position the terminal wall plate over the terminal.2. Mark and drill 4 fixing holes with an 7mm ( 9/32") masonry drill.3. Insert the 4 plastic plugs provided.4. Secure the plate with 4 of the No.10 x 2" screws provided.Note.If the terminal is less than 2m (6' 6") above ground level,an approved terminal guard should be fitted. Refer to theContents List on Page 3.21 TERMINAL WALL PLATE