Ideal Boilers Classic LXFF230 User Manual

Also see for Classic Combi FF 280: Installation and servicing Installation and Servicing Manual

Contents

Supplied By www.heating spares.co Tel. 0161 620 66774 Classic LXFF & FF - User'sTo light the boiler. Refer to Frame 11. CHECK THAT THE ELECTRICITY SUPPLY TO THEBOILER IS OFF.2. Deluxe Model (LX) - Lift the glass fascia and support it withthe sliding catch.Standard Model - Open the controls access door by hingingdownwards.3. Ensure that the gas inlet cock (B) is OPEN.4. Press the overheat reset button (D), located as shown inFrame 1.5. Ensure that the mains on/off switch (E) is in the OFFposition.6. Switch ON the electricity supply to the boiler. Check that allexternal controls, e.g. room thermostat etc., are ON.7. Turn the boiler thermostat knob (C) to position 6 and themains on/off switch (E) to ON. After about 15 seconds theboiler will light automatically - this can be viewed through thesight glass (A).Set the boiler thermostat to the desired position.8. Deluxe Model (LX) - Lower the glass fascia after pushing inthe sliding catch.Standard Model - Close the controls access door.NOTE TO THE INSTALLER: LEAVE THESE INSTRUCTIONS ADJACENT TO THE GAS METERIn winter conditions, i.e. central heating and domestic hotwater, the thermostat should be set at position 5 or 6.For summer conditions, i.e. domestic hot water only, thethermostat should be set at position 3.These settings, however, are offered for general guidance onlyand other settings may be found preferable, dependent upon thetype of system installed or as recommended by the installer.Approximate flow temperatures for the boiler thermostat settingsare:Knob Setting Flow Temperature°C °F1 56 1332 61 1423 66 1524 72 1615 77 1706 82 1801 BOILER CONTROLSLEGENDA SightglassB Gas inlet cock (shown in the OPEN position)C Thermostat knobD Overheat thermostat reset buttonE Mains on/off switchViewinsideboilercontrolsareaDeluxe Model (LX) Standard Model