Ideal Boilers Mexico Super 4100 FF - 4125 FF Installation And Service Manual

Ideal Boilers Mexico Super 4100 FF - 4125 FF Installation And Service Manual Manual pdf 13 page image

13REAR FLUE OUTLETINSTALLATIONMexico Super 4100 FF & 4125 FF - Installation16 CONNECTING THE FLUE TO THE BOILER15 LOCATING THE BOILERA. If the flue assembly can be fitted from the outside,proceed as follows:1. Move the boiler into position ensuring that the flueoutlet is in line with the wall opening.2. Insert the flue assembly ensuring that the flue slidesinto the flue extension and the 3 sealing ring studslocate into the boiler.14 FITTING THE FLUE ASSEMBLYA. Inside fitting.If the flue assembly cannot be fitted from the outside, proceedas follows:1. Insert the flue assembly through the hole far enough to allowthe rubber seal to unfold completely and form an adequateseal on the outside wall.2. Ensure the notch is at the top. This will aid the location ofthe studs into the boiler back panel.3. Proceed to Frame 15, item B.B. Outside fitting.Proceed to Frame 15.1. Secure the flue to the boilerusing the three M5 wing nutsprovided.Note.The sealing ring studs will locate inthe back panel one way only. Thiswill ensure that the terminal iscorrectly aligned.13 FITTING THE FOAM SEAL1. To determine the position for the foam sealmeasure the wall thickness and mark it ontothe flue, measuring from the groove nearthe terminal.2. Wrap the self-adhesive foam strip round theflue, ensuring that the foam is on theterminal side of the line. This seals the gapbetween the flue and the wall.B. If the flue assembly has been fitted from inside proceedas follows:1. Move the boiler into position ensuring that theflue slides into the flue extension tube and the 3sealing ring studs locate into the boiler back panel.