Ihse K471-CT Manual
                               | |
Contents
| 
REPEATER/CROSS- REPEATER14 Rev. : 09/25/20123.3 System SetupTo install your Repeater/Cross- Repeater system:1. Switch off all devices.2. Connect the interconnect cable to the INTERCONNECT socket(s) of the Local Unit andthe Repeater/Cross- Repeater3. Connect the interconnect cable to the INTERCONNECT socket(s) of the Remote Unitand the Repeater/Cross- RepeaterIf you have bought a Cross Repeater, your device will have two CATxconnectors but only one fiber connector. Possibly you have to swap thefiber GBIC from one port to the other to make the unit working properly.To do this, please refer to installation instruction on page 19.If you have bought a Dual Cross Repeater, your device will have twoCATx connectors and two fiber connectors. The units are marked as„Local“ or „Remote“. For a correct installation, please refer toinstallation instruction on page 19. If you want to upgrade a CrossRepeater to Dual Cross Repeater, you need to reconfigure the jumpersettings.To do this, please refer to Setup at the Repeater/Cross- Repeateron page 18.4. Connect the 5V power supply unit to power the unit.Only use the power supply originally supplied with thisequipment or a manufacturer-approved replacement.5. For a dual head system, connect in the same way like described under 2. and 3. theCATx/Fiber cables for the secondary monitor.6. Power up the system |
Related manuals for Ihse K471-CM
manualsdatabase
Your AI-powered manual search engine