www.ikancorp.com 713-272-8822POWERING THE MONITOR1. Plug the AC power adapter into the power input jack (See rear view diagram or above).2. Attach the DV battery plate on the slot, and connect DV battery to the plate.3. Connect a pro battery using the optional pro battery plate and then plugging that plate with the power tap cable intothe DC-In connector. The pro battery plate kits (PBK17-S or PBK17-A) allow you to go into the field using standardV-Mount or Gold-Mount batteries.DIGITAL TO ANALOG CONVERSION [SDI > YUV]The monitor can convert digital SDI signals to Analog YUV. A signal from the SDI will be displayed on the YPbPr analogoutputs. This is a straight digital to analog conversion only. There is no up converting, down converting or standardsconversion available in this feature. This feature works in one direction SDI to analog. It will not work in reverse.6 7++CAUTION: TURN OFF POWERBEFORE ADJUSTINGSWITCHESVIDEOY/CYPbPrSDIINDC 12V-20VDC 12V - 20VOUTHDMI+ +1 HDMI terminalHDMI input onlyVIDEO terminal (BNC)IN : Composite signal input terminalOUT: : Input signal through-out terminalY/C terminalIN : SVHS signal input terminalOUT: : Input signal through-out terminalYPbPr terminal (BNC)IN : Component signal input terminalOUT: : Input signal through-out terminalSDI (HD/SD) terminal (BNC)IN : SDI input terminal - 1.5GOUT: : Input signal through-out terminal (Reclock)DC 12V-20V power terminalStandard DC ConnectionDC 12V-20V power terminalXLR DC ConnectionVesa 100mm Mount HolesThreaded for M4x.07 screws. Use to attach pro batteryplate adapter or for mounting third party vesa mounts.USB terminalFor factory service use only¼-20 Threaded insert (on four sides of monitor)Mounting MonitorDV Battery Plate SlotMounting ikan DV battery plate234567891110123456789101111**NOTE – The user must turn themonitor off before making changes tothe DIP switches. Failure to do so maydamage the monitor or make themonitor unusable.VX9e-DKVX9e Deluxe Kit QUICKSTART GUIDE