Jäger Z62-M260.23 S5 Manual

Tools for high speed cuttingItem no. 10202024, Revision 0226 ( 36 )11 Tools for high speed cuttingDANGER: Due to flying parts.If the wrong direction of rotation is used, the tool is damaged when load isapplied. The centrifugal forces cause the broken part to be flung out.u Only use tools with the correct direction of rotation for the HF spindle.DANGER: Due to flying parts.If the speed is selected incorrectly, the HF spindle or the tool may be de-stroyed and their fragments may be flung out.u Note the maximum speed for the selected tool.u Note the maximum speed for the HF spindle.u Always select the lowest specified speed for machining.Ü Only use tools that are technically sound.Ü Only use tools with a tool shank diameter that corresponds to the inner di-ameter of the collet. For example, do not use shanks with a diameter of 3mm in collets for 1/8” (=3.175 mm).Ä Also see the Technical Specifications [} 12] sectionÜ Only use tool shanks with a diameter tolerance of h6.Ü Do not use tool shanks with a clamping surface (e.g. Weldon).Ü Only use a balanced tool.Ä DIN ISO 1940, balance grade 2,5 .