Jäger Z62-M280.25 S5 Manual

Tool changeItem no. 10202026, Revision 0226 ( 36 )10.2 Manual tool change1 End face2 Clamping nut3 Collet (optional accessory)Proceed as follows to change the tool:Ü Use the hook wrench to unfasten the clamping nut and the collet.Ä Make use of the hook wrench from the scope of delivery of the HF spindle.Ü Remove the tool.Ü Screw the clamping nut out.Ü Remove the collet from the taper of the mount.Note: Ensure functionality.All contamination damages the collet, clamping nut, tool mount, etc. As a re-sult, the function of the HF spindle is no longer guaranteed.u Clean the collet.u Clean the clamping nut.u Clean the thread of the shaft.u Clean the inner taper of the shaft.Ü Lightly grease the thread of the clamping nut.Ü Push the collet into the taper of the mount.Ü Insert the tool.Ü Make sure that the shank of the clamped tool does not press on the innerstop of the tool mount once the clamping nut has been tightened.Ü To prevent the clamping nut from loosening, tighten it again after a shortperiod of operation and when the shaft is at a standstill.10.2.1 Maximum tightening torquesShort clamping boreContinuous clamping boreExcessive tightening torques (MA) can damage or destroy the collet, clampingnut, and collet mount of the shaft.Keep to the following values.Ü Short clamping boreÄ Clamping diameter: 1,0 - 2,5 mmÄ Ma max.: 11 NmÜ Continuous clamping boreÄ Clamping diameter: 3,0 - 7,0 mmÄ Ma max.: 18 Nm