― 17 ―4 System setupThis section provides a generic procedure for aligning one or more Drive5 system and associatedequipment at a site.The example installation process described in this section assumes that: The cameras are being mounted on an overhead structure directly over the lane(s) beingobserved. The process for aligning a camera mounted at the side of a lane is essentially thesame as aligning a single camera mounted directly overhead. The unit employs vehicle detection that will automatically trigger the camera (see Section4.7). To determine where the vehicle will trigger, the EN Setup program can be made todisplay a trigger area region. This function is enabled by clicking on Debug Output Mask inSection 1 of the EN Setup camera properties and selecting ”On Image Graphics” as shownbelow.This region shows the area where the camera will detect a moving vehicle. This will give theapproximate trigger line. Since the unit is using motion detection technology, the trigger linewill vary a little depending on the speed of the vehicle. If the installation utilizes other modes for triggering, the unit can also accept a discrete TTL orEthernet signal to the Drive5 system whenever the back (or front) of a vehicle crosses a fixedline across the road. This line is referred to as the “trigger line” in this document. The installer should be familiar with using the EN Setup program supplied by JAI. Make sureyou are using the latest version by checking at www.jai.com. Please refer to the EN SetupProgram User’s Guide if you are unfamiliar with this software. JAI offers engineering support