LQ-050CL64. Locations and functions4.1. Locations and functionsFig. 1 Location of external features1 Lens mount M52 mount (*1)Note)2 Camera Link part 1 base connector (1) (*2)Note)3 Camera Link part2 medium connector (2) (*2)Note)4 12-pin Hirose connector DC +12, External trigger and RS-232C5 DIP switch SW-1 ( refer to chapter 4.2 for the details)6 Button For one-push auto white balance7 LED indicator Power, trigger input and operation indications8 Camera mounting holes 8 x M4, depth 6mmmm (*3) Note)*1) Note: Rear protrusion on M52 mount lens must be less than 13mm.*2) Note: When a CameraLinkTM cable is connected to the camera, please do not excessively tightenscrews by using a driver. The CameraLink receptacle on the camera might be damaged.For security, the strength to tighten screws is less than 0.291 Newton meter (Nm). Tighteningby hand is sufficient in order to achieve this.*3) Note: The depth of mounting hole is 5.5mm . If the longer screws than 6mm are used,they may damage the circuit board inside.
