JBL 4305P Owner's Manual

ENPg 3 of 114305P OM | Part No: 950-0597-001 | Rev 1.0© 2022 HARMAN International Industries, Incorporated. All rights reserved.4. General Placement / Set-upRoom PlacementPosition each speaker in a vertical orientation with the tweeter on the top. The speakers shouldbe placed so the listening position and the two speakers form an equilateral triangle.On the back of the Primary speaker, set the bass contour switch based on the speaker'sproximity to side boundaries such as walls, inside a bookcase / cabinet, or on floor stands.Recommended Bass Contour settingsWhen positioned away from side boundaries or on a stand set to 0dB.When positioned close to side boundaries or when the speaker is inside of a cabinet orbookcase set to -3dB.On the back of the Primary speaker, set the L/R Assign switch to identify the Primary speakerbased on your selected positioning.Speaker System Set-up1. Make sure AC Main switch is set to Off.2. Connect the provided AC cords between the AC Inlets on the back of both speakers and the other end to your home AC outlet.3. Connecting the Primary Speaker to the Secondary Speaker:a. Hardwired: Attach one end of the supplied CAT6 cable to the Digital Link connector on the back of the Primary speaker andthe other end to the Digital Link connector on the back of the Secondary speaker. Maximum CAT5 cable length 23' (7m). Thiswill deliver the highest level of audio quality at 192kHz / 32bit between the two speakers. Both speakers Power LEDs willilluminate solid Yellow when tethered together.b. Wireless: Each pair of 4305P have been pre-paired for wireless connectivity at the factory. Maximum distance betweenspeaker should be 30' (9m) or less. Maximum audio quality through wireless connection is 96kHz 24bit. Both speakers PowerLEDs will illuminate solid White when connected wirelessly.i. Wireless Note: If for some reason the speakers in this system become un-associated from each other follow thefollowing steps:1. Verify both speakers are On.2. On the back of the Secondary speaker, Press and Hold the Sync button for >3 seconds. The Power LED willilluminate and flash Yellow color.3. On the back of the Primary speaker, Press and Hold the Sync button for >3 seconds. The Power LED will illuminateand flash Yellow color.4. When association is successfully completed, both Primary and Secondary speaker Power LEDs will Illuminate solidGreen.4. Turn the volume down located on the Primary speaker.5. Set the AC main switch on the back of both speakers to On.Note: When powered up, the system will boot-up, indicated by all LEDs on the front panels flashing White. Once the boot-up processis completed, the system automatically enters an initial network setup mode.BASSCONTOUR0dB-3dBBASSCONTOUR0dB-3dBL/RASSIGNLR��°��°