JBL 700 User Manual

Also see for 700: Quick start guide Quick start guide Quick start guide

Contents

543 2 1123 4 5NETWORK CONNECTIONSTwo latching 5-pin XLR connectors are fitted for RS-485network interconnections. A PC running WinControl maybe connected, via an appropriate interface (either RS-232to RS-485 or USB to RS-485) to the Input connector, ifcontrol and monitoring during operation are required. TheLink connector (male) is to facilitate easy connection toanother WinControl-supported device (e.g. an adjacentenclosure).The network connectors should be wired as follows:See page 11 for information regarding suitable networkcable types. See Section 7 (Configuring with WinControl) formore information about network operation and softwareoptions.User Guide - AXYS ®UniAmp Power Amplifier Module , Model 7004. PRESETSThe UniAmp 700’s DSP section includes 8 Presets;memory locations in which sets of configuration pa-rameters can be stored. These permit the loudspeakercabinet to be “fine-tuned” to suit different types ofprogramme material and venue.When a settings file is loaded into the unit from aPC, the user can specify in WinControl which Presetmemory it will be loaded into.RECALLING PRESETSThe simplest method of recalling a previously-savedPreset is via WinControl. This necessitates a networkconnection to the loudspeaker system. Refer to theWinControl Help files for further information.If a network connection is not in place, or a PC withWinControl is unavailable, Presets may be recalledmanually using the Reset & Preset Control button*.This button is hidden behind a small access hole onthe amplifier module’s conector panel, and can beaccessed with an implement such as a fine jewellers’screwdriver or a straightened-out paper clip.A single short press (< 1 sec) on this button willincrement the current Preset number, i.e. if the systemis currently running Preset 2, pressing the button willload Preset 3. While the button is pressed, the StatusLED will change colour from green to red. Loading ofthe next Preset is confirmed by the LED flashing theappropriate number of times, i.e., it will flash 3 timeswhen Preset 3 is loaded. Using this method, repeatedbutton presses will load each Preset in turn.Note that the amplifier module alwayspowers-up with the last-used Preset active.Note also that a long (> 1 sec) button presshas a different function (see following page).*Please note that this feature may not be available on Target U-16 enclosures with early serial numbers. Please contact yourAXYS®dealer for more information.8 200905/UAUG_v1.0PIN # Function1 Screen2 Data Tx +3 Data Tx -4 Data Rx -5 Data Rx +