JBL Bar 3.1 Owner's Manual

Also see for Bar 3.1: Owner's manual User manual

Contents

5www.jbl.comEnglishIf no audio from the wireless subwoofer can be heard, manuallypair the subwoofer:1. Turn on the soundbar and the subwoofer. If the connection islost, the LED indicator on the subwoofer blinks slowly.2. Press the CONNECT button on the subwoofer to enter pairingmode. The LED indicator on the subwoofer blinks quickly.3. Press and hold DIM DISPLAY button on remote control for5 seconds, followed by short press on BASS+, and BASS-button in sequence. Panel display will show “PAIRING”If the pairing succeeds, the LED indicator on the subwooferlights up and the soundbar display will show “DONE”.If the pairing fails, the indicator on the subwoofer blinks slowly.4. If the pairing fails, repeat the steps above.4. PLACE YOUR SOUNDBAR4a. Place the Soundbar on the table4b. Wall mount the SoundbarUse tape to stick the wall-mounted paper guide on the wall, pusha pen tip through the center of each mounting hole to mark thewall-mounted bracket location and remove the paper.TVScrew the wall mount brackets on the pen mark; screw thethreaded mounting post into the back of the soundbar; then hookthe soundbar on the wall.≤8 mm/0.31"4mm/0.16"≥35 mm/1.4"1235. USE YOUR SOUNDBAR SYSTEM1. To Controla. Top panelb. Remote Control76421538913151719101112141618* Switch between HDMI ARC/ HDMI 1/ HDMI 2/ HDMI 3/ Optical/ AUX/ Bluetooth/USB** Switch between Standard/ music/voice/ movie/ sports sound mode or press andhold 5 seconds to reset default audio setting*** For USB playback only; switch between shuffle/ repeat all/ repeat one/ off2. To use Bluetooth2a. Press Bluetooth (BT) button on your remote controlto start Bluetooth pairingPAIRING1) Power2) Source*3) Play / Pause4) Volume +5) Volume -6) Previous7) Next8) Audio Sync +9) Audio Sync -10) Mute11) Bass +12) Bass -13) Sound mode**14) Soundshift On / off15) Shuffle / Repeat***16) Surround On / off17) Night mode On / off18) Dim display19) BluetoothPower VolumeDown VolumeUp Source