JBL Control 24C/CT Micro Owner's Manual

Contents

1 - Cable Tie - If using loose wire, this cable tie can secure the loose ends of wire thatare connected to the terminal block. The strap can be tightened by pulling on the looseend and then tightening the holding screw.2 - Adjustable Metal Strap - This adjustable steel tie fitting is provided for those applica-tions where it can be utilized to affix a set of wires. It can be useful for regions wheresuch a fitting is allowed for terminating a flexible conduit. It can also be used for tight-ening down onto incoming wires to provide strain relief. It might be necessary to placeelectrical tape or heat shrink over any wire bundle, underneath the metal strap, to physi-cally protect the wire from the strap.3 - PEM Screws - Two screws, which are threaded into PEM fittings in the backcan,one on the back and one on the side, can be used to attach a wide variety of strain fit-tings. Please remove the correct screws with the PEM fitting, as shown on the ProductFeature Identification Picture on Page 3, NOT the two screws that hold the backcan inplace. Check building codes in your area for what kind of physical strain relief fittingsare required in your region.Always use the proper fitting in accordance withyour area's building codes and regulations.CAUTION:Figure 7:Tightening the Cable Tie9