JBL DVD600II Service Manual
Also see for DVD600 II: Owner's guide
                                                               | |
Service BulletinService Bulletin JBL2003-01 Rev1 - June 2003 This is considered a Minor repairTo: All JBL Service CentersModel: DVD600II (Cinema ProPack 600II system)Subject: Unit Says In Standby ModeIn the event you receive a DVD600II DVD player with the complaint: “The unit stays in standby mode(amber indicator), and will not switch ON, either with the remote control or the front panel button”,check the following components and follow the instructions below:Synopsis:In the Front panel PCB:IC901 microprocessor - check solder connections to all 80 pins – resolder if necessaryC903, C904 0.1uF 50V SMD capacitors – check and replace.In the Power supply PCB:R6 120Ω 1/8 watt resistor – check and replace if necessary.1) Remove (8) screws holding the top cover on; remove the cover.2) In the Power supply PCB, check and replace R6, 120Ω 1/8 watt resistor, with JBL part# 299-120. Youmay be able to cut the defective resistor off the PCB and re-solder the new part on without removing thepower supply PCB.3) Remove the five plated screws holding the front panel to the chassis (one is on the bottom)4) Unplug the single 5-pin Molex plug to CN906 (near the power switch) to allow the front panel to bedisengaged from the chassis; cut and remove any cables ties, but note their location.5) Remove the front panel from the unit; there are four tabs/catches that must be freed as the panel isremoved; two are on the sides and two are on the bottom.6) Once the rear of the front panel PCB is exposed, locate IC901 microprocessor - check solderconnections to all 80 pins and resolder if required.7) Locate C903, C904; 0.1uF 50V SMD capacitors; check and replace with JBL part# 2026729091.8) Replace any cable ties that were cut; reassemble and test unit.Model Serial number(120v)Serial number(230v) Status ActionDVD600II All Serial numbersaffectedAll Serial numbersaffectedMay need modification ifunit exhibits symptomCheck solder connections to IC901Check and replace C903,C904 and R628DVD600II |
Related manuals for JBL DVD600 II
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine