4This equipment complies with the EMC directive 89/336/EECModified by92/31/EEC93/68/EEC98/13/EEC and LVD 73/23/EEC modified by 93/68/EECThis product meets safety standards:EN60065:2002UL6500 7th Edition: 2003UL 60065 - STANDARD FOR AUDIO, VIDEO AND SIMILAR ELECTRONICAPPARATUS - SAFETY EQUIREMENTS - Edition 7 - Revision Date 2007/12/11CSA C22�2 NO 60065-03 - AUDIO, VIDEO AND SIMILAR ELECTRONICAPPARATUS – SAFETY REQUIREMENTS - Edition 1 - Revision Date 2006/04/01IEC 60065 - AUDIO, VIDEO AND SIMILAR ELECTRONIC APPARATUS -- SAFETYREQUIREMENTS - Edition 7�1 - Issue Date 2005/12/01And EMC StandardsEN55103-1 (E2)EN55103-2 (E2)This device complies with Industry Canada’s licence-exempt RSSs� Operation is subject to the following two conditions:(1) This device may not cause interference; and(2) This device must accept any interference, including interference that may cause undesired operation of the device.Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence�L’exploitation est autorisée aux deux conditions suivantes :(1) l’appareil ne doit pas produire de brouillage;(2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’encompromettre le fonctionnement�Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority tooperate the equipment�FCC Compliance NoticeThis device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device maynot cause harmful interference, and (2) this device must accept any interference received, including interference that maycause undesired operation�CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could void the user’sauthority to operate the equipment�NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to partof the FCC Rules� These limits are designed to provide reasonable protection against harmful interference in a residentialinstallation� This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used inaccordance with the instruction manual, may cause harmful interference to radio communications� However there is noguarantee that the interference will not occur in a particular installation� If this equipment does cause harmful interference toradio and television reception, which can be determined by turning the equipment off and on, the user is encouraged to try tocollect the interference by one or more of the following measures�• Reorient or relocate the receiving antenna• Increase the separation between the equipment and receiver• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected• Consult the dealer or an experienced radio/TV technician for help• FCC RADIATION EXPOSURE STATEMENTThis device complies with FCC radiation exposure limits set forth for an uncontrolled environment� This device should beinstalled and operated with minimum distance 20cm between the radiator & your body�Section 3: EON ONE PA System Declaration of Conformity