6Section 3: EON 206P PA System Declaration of ConformityThis equipment complies with the EMC directive 89/336/EECModified by92/31/EEC93/68/EEC98/13/EEC and LVD 73/23/EEC modified by 93/68/EECThis product meets safety standards:EN60065:2002UL6500 7th Edition: 2003UL 60065 - STANDARD FOR AUDIO, VIDEO AND SIMILAR ELECTRONICAPPARATUS - SAFETY EQUIREMENTS - Edition 7 - Revision Date 2007/12/11CSA C22.2 NO 60065-03 - AUDIO, VIDEO AND SIMILAR ELECTRONICAPPARATUS – SAFETY REQUIREMENTS - Edition 1 - Revision Date 2006/04/01IEC 60065 - AUDIO, VIDEO AND SIMILAR ELECTRONIC APPARATUS -- SAFETYREQUIREMENTS - Edition 7.1 - Issue Date 2005/12/01And EMC StandardsEN55103-1 (E2)EN55103-2 (E2)FCC Compliance NoticeThis device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) Thisdevice may not cause harmful interference, and (2) this device must accept any interference received, includinginterference that may cause undesired operation.CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could voidthe user’s authority to operate the equipment.NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device,pursuant to part of the FCC Rules. These limits are designed to provide reasonable protection against harmfulinterference in a residential installation. This equipment generates, uses, and can radiate radio frequency energyand, if not installed and used in accordance with the instruction manual, may cause harmful interference to radiocommunications. However there is no guarantee that the interference will not occur in a particular installation. Ifthis equipment does cause harmful interference to radio and television reception, which can be determined byturning the equipment off and on, the user is encouraged to try to collect the interference by one or more of thefollowing measures.• Reorient or relocate the receiving antenna• Increase the separation between the equipment and receiver• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected• Consult the dealer or an experienced radio/TV technician for help