JBL GTO-1001EZ Owner's Manual

Contents

JBL GTO-1001EZ Owner's Manual Manual pdf 5 page image

5www.jbl.comEnglishpower connection1. Connect a wire (minimum 6AWG – 13.2mm 2 – for the GTO-1001EZ; minimum 8AWG – 8.4mm 2 –for theGTO-751EZ and GTO-501EZ) directly to the battery’s positive (+) terminal.2. Install a fuse holder for a 120A fuse (GTO-1001EZ), 80A fuse (GTO-751EZ) or 50A Fuse (GTO-501EZ) on this wirewithin 18" (46cm) of the battery’s (+) terminal. Do not install the fuse in the holder at this time.3. Route this wire to the amplifier’s location and connect it to the amplifier’s +12V terminal. Be sure to useappropriate grommets whenever routing wires through the firewall or other sheet metal. impOrtant: Failure toadequately protect the positive wire from potential damage may result in a vehicle fire.4. When you are finished routing and connecting this wire, install the appropriate fuse in the holder you installed nearthe battery. (GTO-1001EZ = 120A fuse; GTO-751EZ = 80A fuse; GTO-501EZ = 50A fuse.)suBWOOfer cOnnectiOnConnect the subwoofer to the amplifier’s Sub (+) and (–) terminals.-SubwooferGTOSubwoofer AmplifierAlways connect the (+) terminal on the amplifier to the (+) terminal on the subwoofer and the (–) terminal on theamplifier to the (–) terminal on the subwoofer.impOrtant: Make sure the (+) and (–) bare wires do not touch each other or the other terminal at both the amplifierterminals and subwoofer terminals. Touching wires can cause a short circuit that can damage the amplifier.nOte: The minimum subwoofer impedance is 2 ohms.