JBL GTO-804EZ Owner's Manual

Contents

JBL GTO-804EZ Owner's Manual Manual pdf 7 page image

7www.jbl.comEnglishcOnnecting the inputsUse RCA audio cables to connect source units with preamp-level outputs to the amplifier; use the supplied bare wire-to-RCA adapters to connect to source units that don’t have RCA output connectors.Use a small Phillips screwdriver to loosen the adapter’s set screws and insert the speaker wires into the holes on theback of the adapter. Tighten the set screws to secure the wires.LoosenScrew InsertWire TightenScrewAlways connect the (+) speaker wire to the (+) terminal on the adapter and the (–) speaker wire to the (–) terminal onthe speaker.impOrtant: Make sure the (+) and (–) bare wires do not touch each other. Touching wires can cause a short circuitthat can damage the source unit or the amplifier.When you’re finished, plug the adapter into the appropriate input connector on the amplifier.• For bridged operation: Connect to the left input of each bridged channel pair.auX Out cOnnectiOnsThe Aux Out connectors are unfiltered pass-through output connections that let you connect multiple amplifiers to asingle source unit, such as when you’re using separate amplifiers for front/rear speakers and a subwoofer. Connectthe GTO-804EZ/GTO-504EZ’s Aux Out connectors to the subwoofer amplifier's input connectors.Source UnitAux Outputs SubwooferAmplifierGTO-804EZ/GTO-504EZRearOutputsFrontOutputsThe Aux Out connectors are fed by both the GTO-804EZ/GTO-504EZ’s front and rear inputs, so the subwoofer ampwill receive an input signal regardless of how the source unit's fader control is set.