WARNING FOR YOUR PROTECTIONREAD THE FOLLOWING:KEEP THESE INSTRUCTIONSHEED ALL WARNINGSFOLLOW ALL INSTRUCTIONSThe apparatus shall not be exposed to dripping or splashing liquid and no object filled with liquid,such as vases, shall be placed on the apparatus.CLEAN ONLY WITH A DRY CLOTH.DO NOT BLOCK ANY OF THE VENTILATION OPENINGS. INSTALL IN ACCORDANCE WITH THE MANUFAC-TURER’S INSTRUCTIONS.DO NOT INSTALL NEAR ANY HEAT SOURCES SUCH AS RADIATORS, HEAT REGISTERS, STOVES, OROTHER APPARATUS (INCLUDING AMPLIFIERS) THAT PRODUCE HEAT.ONLY USE ATTACHMENTS/ACCESSORIES SPECIFIED BY THE MANUFACTURER.UNPLUG THIS APPARATUS DURING LIGHTNING STORMS OR WHEN UNUSED FOR LONG PERIODS OFTIME.Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has twoblades with one wider than the other. A grounding type plug has two blades and a third groundingprong. The wide blade or third prong are provided for your safety. If the provided plug does not fityour outlet, consult an electrician for replacement of the obsolete outlet.Protect the power cord from being walked on or pinched particularly at plugs, convenience recep-tacles, and the point where they exit from the apparatus.Use only with the cart stand, tripod bracket, or table specified by the manufacture, or sold with theapparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoidinjury from tip-over.Refer all servicing to qualified service personnel. Servicing is required when the apparatus has beendamaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled orobjects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does notoperate normally, or has been dropped.POWER ON/OFF SWITCH: If the equipment has a Power switch, the Power switch used in this pieceof equipment DOES NOT break the connection from the mains.MAINS DISCONNECT: The plug shall remain readily operable. For rack-mount or installation whereplug is not accessible, an all-pole mains switch with a contact separation of at least 3 mm in eachpole shall be incorporated into the electrical installation of the rack or building.FOR UNITS EQUIPPED WITH EXTERNALLY ACCESSIBLE FUSE RECEPTACLE: Replace fuse with sametype and rating only.MULTIPLE-INPUT VOLTAGE: This equipment may require the use of a different line cord, attachmentplug, or both, depending on the available power source at installation. Connect this equipment onlyto the power source indicated on the equipment rear panel. To reduce the risk of fire or electric shock,refer servicing to qualified service personnel or equivalent.If connected to 240V supply, a suitable CSA/UL certified power cord shall be used for this supply.The symbols shown above are internationally accepted symbolsthat warn of potential hazards with electrical products. Thelightning flash with arrowpoint in an equilateral triangle meansthat there are dangerous voltages present within the unit. Theexclamation point in an equilateral triangle indicates that it isnecessary for the user to refer to the owner’s manual.These symbols warn that there are no user serviceable parts insidethe unit. Do not open the unit. Do not attempt to service the unityourself. Refer all servicing to qualified personnel. Opening thechassis for any reason will void the manufacturer’s warranty. Donot get the unit wet. If liquid is spilled on the unit, shut it offimmediately and take it to a dealer for service. Disconnect theunit during storms to prevent damage.ELECTROMAGNETICCOMPATIBILITYThis device complies with part 15 of the FCC Rules andthe Product Specifications noted on the Declaration ofConformity. Operation is subject to the following two condi-tions:• this device may not cause harmfulinterference, and• this device must accept any interference received,including interference that may cause undesired opera-tion.Operation of this unit within significantelectromagnetic fields should be avoided.• use only shielded interconnecting cables.IMPORTANT SAFETY INFORMATION