JBL ON BEAT VENUE LT Quick Setup Manual

2PLACEMENTPlace OnBeat VenueLTon a shelf or table with the rear of its enclosureisat least 3..(76mm) away from a wall or other surface to allow the bass ports to operate properly.CONTROLS AND INDICATORSMovie Aux InputButtonLEDBass Boost SourceButtond~-~Button®@®Dock InputLED8/uetoothLEDPower Volume Up/DownButton~~Buttons® E +)..:....,______Docking Slide(open)===l:±±::::::lL...--------LTDocking ConnectorBass Boost button: Press this button to enhance the bass performance. The button'sLEDwill illuminate when Bass Boostison.Movie button: Press this button to activate the MovieEOmode, which createsanextra-wide sound field to compliment films and other video media. The button's LED willilluminate when the Movie mode is on.Source button: Press this button to cycle through the audio sources: 8/uetooth, dockeddevice and Aux Input. The input LED for the active source will illuminate.• If you begin to stream audio from a paired 8/uetooth device or play audio from a deviceconnected to the dock while another source is playing, the OnBeat VenueLTwillautomatically switch to the new source.Aux Input LED: This LED illuminates when the Aux Input is the active source.Dock Input LED: This LED illuminates when the docked device is the active source.8/uetooth LED: This LED flashes blue when the OnBeat VenueLTis inthe 8/uetoothpairing mode, and turns solid blue when it has successfully paired with a 8/uetooth device.Power button: When the OnBeat VenueLT is on, press the Power button to put it into thestandby mode. The button's LED will illuminate solid amber when the unit is in standby.When the OnBeat VenueLTis in standby, press the Power button to turn it on. The button'sLED will illuminate solid white when the unit is on.