JBL STUDIO L820 Owner's Manual

Also see for L Series: Operator's guide Troubleshooting Manual Technical manual Technical manual

Contents

JBL STUDIO L820 Owner's Manual Manual pdf 2 page image

MODELS: L810,L820Receiver’s Speaker OutputsMODEL: LC2Receiver’s Speaker OutputsSpeakers and electronics havecorresponding (+) and (–)terminals. It is important toconnect both speakers identi-cally: (+) on the speaker to (+)on the amplifier and (–) on thespeaker to (–) on the amplifier.Wiring “out of phase” resultsin thin sound, weak bass andpoor imaging.To use the binding-postspeaker terminals, unscrewthe colored collar until thepass-through hole in the cen-ter post is visible. Insert thebare end of the wire throughthis hole; then screw the collardown until the connectionis tight.The hole in the center of eachcollar is intended for use withbanana-type connectors. Tocomply with European CEcertification, these holes areblocked with plastic inserts atthe point of manufacture. Touse banana-type connectorsrequires the removal of theinserts. Do not remove theseinserts if you are using theproduct in an area covered bythe European CE certification.BI-WIRINGThe bi-wire connectionmethod requires one amplifierand two sets of speaker wires.By removing the shorting bars,connections may be made tothe individual network sectionsusing four conductors, one foreach of the four terminals.For single-wire connection,leave the shorting bars inplace and connect only a sin-gle set of speaker wires (twoconductors) to the two upperterminals.Bi-Wire Connections– +– +– +AmplifierHigh FrequencyLow Frequency– +– +– +– +– +Receiver’s Speaker OutputsLEFTLEFTRIGHTRIGHT– +SPEAKER CONNECTIONSMODELS: L810,L820, LC2The supplied self-adhesiverubber feet may be attachedto the bottom corners of yourspeakers to protect yourfurniture.Place pads hereSPEAKER SETUP

/ 5

Related manuals for JBL L Series