JBL VENUE SUB12 Owner's Manual
Also see for Venue SUB12: Service manual
        | |
SYSTEM CONNECTIONSIf you have a Dolby® Digital or DTS® receiver/processor with alow-frequency-effects (LFE) or subwoofer output:If your receiver/processor does not have subwoofer outputsfor the left and right channels or an LFE output, connectspeaker wire from your receiver/amplifier to your speakersand subwoofer using two sets of speaker wire:5If your receiver/processor does not contain a Dolby Digitalor DTS processor, but has subwoofer outputs:Set line-level/LFE switch to“Normal.”NOTE: If your receiver/processorhas only one sub out, you mayuse either the L or R input.CROSSOVERFREQUENCYLEVELLINE LEVEL INPHASEMin MaxLRL RFor LFE use L or RLFE NORMALHIGHLEVELIN50Hz0º 180º150HzRECEIVER/AMPLIFIERFront Speaker Output80HzGreen: OnRed: StandbyPS-10/PS-12CAUTIONRISK OF ELECTRIC SHOCKDO NOT OPEN120V60HzCROSSOVERFREQUENCYLEVELLINE LEVEL INPHASEMin MaxLRL RFor LFE use L or RLFE NORMALHIGHLEVELIN+ –50Hz0º 180º150HzPOWERON OFFRECEIVER/PROCESSOR80HzL RGreen: OnRed: StandbyPS-10/PS-12CAUTIONRISK OF ELECTRIC SHOCKDO NOT OPEN120V60HzCROSSOVERFREQUENCYLEVELLINE LEVEL INPHASEMin MaxLRL RFor LFE use L or RLFE NORMALHIGHLEVELINLRHIGHLEVELOUT+ –50Hz0º 180º150HzPOWERON OFFSUBWOOFER ORLFE OUTPUT80HzGreen: OnRed: StandbySet LFE/Normal switch to “LFE.”This figure shows how to connect bare wires to the terminals. |
Related manuals for JBL Venue SUB12
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine