JETWAY 848PTR2A User Manual
Also see for 848PDA: User manual
                                                    | |
Contents
| 
12Do not use AGP 2X card (3.3V) in this motherboard. It will burn and damage themotherboard due to Intel® 848 chipset can not support AGP 2X (3.3V).IMPORTANT! Before you plug-in AGP card, please make sure the following notice isfully understood and practiced. If your AGP card has “AGP 4X notch(show below) please make sure your AGP card is AGP 4X/8X(1.5V/0.8V) not AGP 2X (3.3V)AGP SLOTExample 1: SiS 305 & ATi Rage 128 Pro AGP card those golden finger is compatiblewith 2X/4X mode AGP slot, but only can support 2X (3.3V) only. If youinstall these cards in Intel® 848 based motherboard it will burn and damagethe motherboard.Example 2: We also find Diamond Vipper V770 golden finger is design for 2X/4X modeAGP Slot. It can be adjusted the jumper for AGP 2X (3.3V) or AGP 4X(1.5V). But the factory default setting is 2X (3.3V). If you install this AGPcard in motherboard without change the jumper setting to 4X (1.5V), it willburn the motherboard.2-6 Connectors, Headers2-6-1 Connectors(1) Power Connector (20-pin block) : ATXPWRATX Power Supply connector. This is a new defined 20-pins connector that usually comeswith ATX case. The ATX Power Supply allows to use soft power on momentary switch thatconnect from the front panel switch to 2-pins Power On jumper pole on the motherboard.When the power switch on the back of the ATX power supply turned on, the full power will notcome into the system board until the front panel switch is momentarily pressed. Press thisswitch again will turn off the power to the system board.2x notch 4x notch |
Related manuals for JETWAY 848PDA
manualsdatabase
Your AI-powered manual search engine